PSC PT2000 Betriebsanweisung PDF herunterladen (Seite 129)

NiCd Battery Pack

User’s Guide 119

8. Replace the hand-strap hook into its holder.

Recharging the NiCd Battery Pack

If the portable will not turn on or if the message LOW BATTERY appears

on the display, the battery pack needs recharging. To recharge the NiCd

battery pack, use a cable and an external 9-volt power adapter (refer to

Figure D-1 on page 109). A full charge takes about eight hours.

To recharge the NiCd battery pack, complete the following steps:

1. If the portable is on, turn it off.

2. One of the connectors on the cable has the cable number on it.

Plug that connector into the cable input jack on the bottom of the

portable.

3. Attach the small, round plug of the 9-volt power adapter to the

round power input jack on the cable connector labeled

COMPUTER. Plug the other end into an outlet or power strip.

Use the PT Dock to recharge the NiCd batteries. Leave the batteries in

the unit while it is in the Dock. The batteries recharge while the

READY

light is on. (Make sure

Switch 2 in the portable’s battery compartment is

in the

NiCd position; refer to Figure E-1.)

Caution: Do not short-circuit a battery—damage to the battery

can result. Do not incinerate, crush, or puncture

batteries. The electrolyte contained in NiCd batteries is

composed of caustic materials that are harmful to the

eyes and skin. Dispose of batteries in compliance with all

applicable regulations.

Caution: Use only a power adapter supplied by a PSC dealer.

Using another adapter can damage the unit.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 167 168

Keine Kommentare

PSC PT2000 Betriebsanweisung Seite 129