PSC LINEAR IMAGER 7000 Wartungshandbuch PDF herunterladen (Seite 13)

Getting Started

Quick Reference Guide 5

Host Connection —

The interface type was specified at the time your

scanner was ordered, however you should verify before connection that

the scanner’s cable type is compatible with your host equipment. Most

connections plug directly into the host device as shown in

Figure 3. Key-

board Wedge interface cables have a ‘Y’ connection where its female end

mates with the male end of the cable from the keyboard and the remain-

ing end at the keyboard port on the terminal/PC.

Figure 3. Connecting to the Host

Linking the Scanner to a Base Station

To link a scanner to a Base Station, press the Link Button on the Base

Station (see

Figure 4) for at least one second to place the base in "Link

Mode"then scan the “

Link to a Base Station” bar code below or the link

bar code located on the Base Station itself using the scanner to be linked.

Allow the system several seconds to create the association between the

two units and exit Link Mode. A successful link is indicated by three

or...

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Keine Kommentare

PSC LINEAR IMAGER 7000 Wartungshandbuch Seite 13