PSC Scanners Spezifikationen PDF herunterladen (Seite 69)

100

101

Product Reference Guide 3-7

Additional Functions

Additional scanner and scale functions include programming, running

scanner or scale diagnostics, initiating a reset, zeroing the scale, and cali-

brating the scale.

Programming

When your scanner or scanner/scale is shipped from the factory it is con-

figured to work with the POS system interface at your store and read the

bar code symbologies you designated. If you need to change this configu-

ration information for any reason, Section 6, Programming, contains spe-

cial bar code labels for changing the unit’s settings.

Diagnostic Mode

Refer to Section 2, Diagnostic Modes for details about running scanner and

scale diagnostics. Error Codes and Corrective Action in Section 4 provides a

table of error codes resulting from diagnostics.

Scanner and Scale Reset

The reset procedures and indicators are identical for scanner and scanner/

scale models. As with any electronic equipment, it is sometimes necessary

to reset the electronics. The reset procedure allows you to initiate a reset

command to the scanner. This may be necessary if the POS terminal has

been switched off or the store system has been reset while the unit is on.

Reset can also be used to initiate and run the unit’s internal Selftest rou-

tine.

Pressing and holding the Volume/Tone Push Button for approximately ten

seconds initiates a reset, which is sounded by a rapid number of beeps. If

the motor had been spinning, the lamps will blink while the motor spins

down. At that point, the motor will spin back up and the scanner will con-

tinue to run the Selftest diagnostics. For more information, see the topic,

Power-Up/Selftest & Pre-Operation earlier in this section.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 439 440

Kommentare zu diesen Handbüchern

Keine Kommentare

PSC Scanners Spezifikationen Seite 69

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Barcodeleser PSC Scanners